Data Loading...
TFH TEXTURED/TACTILE WALLS
30 Downloads
223.3 KB
Twitter Facebook LinkedIn Copy link
RECOMMEND FLIP-BOOKS
Wonder Walls
Wonder Walls 9TWKK, 9TWGV Separate Collection Separat samling Recolección separada Apar
Catalogue TFH 2022 FR
1 800-361-0378 Soyez attentif toujours superviser l’utilisation 40 Proprioception | Vibration Le tou
Catalogue TFH 2022 ANG
1 800-361-0378 Fax: 514 273-8627 Be aware and always supervise use. 46 Proprioception | Weighted Wei
TFH Catalog 2021 (Eng)
1 800-361-0378 Fax: 514 273-8627 Be aware and always supervise use. 38
TFH SENSORY ROOM TRAINING
TFH SENSORY ROOM TRAINING SENSORY ROOM TRAINING SENSORY IS OUR SPECIALTY [email protected]
TFH Sensory Room Development Guide
Sensory Rooms throughout the world for over 25 years. Our consultants are trained by experts in the
TFH Inspiration Sinnesstimulering Äldreomsorg
u n d e r v i s e r SOS U S k o l e n Ny k ø b i n g ”
KLAD™ Leather Walls By Keleen Leathers
KLAD™ Leather Walls By Keleen Leathers Page 1 Page 2 Page 3 Page 4 Page 5 Page 6 Page 7 Page 8 Page
Wood Mounting Blocks
Holes to fasten wall to mounting blocks.
Holes to mount blocks to room wall
Cutout for baseboard trim
Textured/Tactile Walls are mounted to a room wall via 2”x 2” mounting blocks that need to be fastened to the room wall first. The unit is shipping with the three mounting blocks attached inside.
1.
Position the Textured Wall or Tactile Loopie Wall against the room wall (with bottom resting on the floor), where the unit is to be located. Lightly make a pencil mark on the room wall where it meets the edge of the Textured/Tactile Wall (Mark “A” on the diagram right). Also lightly make a pencil mark on the room wall that aligns with the screw holes on the top and sides of Textured/Tactile Wall. (Mark “B” on the diagram right). Move the Textured/Tactile Wall away from the room wall. Redraw the lines from Step #2 offset by ½ inch. See Mark “C” on the diagram to the right. This ½” offset allows for the thickness of side and top panels of the Textured/Tactile Wall. Remove the 2”x2” mounting blocks from the unit. Align the mounting block with Mark “ C ” and Mark “B” as shown in the diagram. Mark on the wall, the location of the holes that mount the blocks to the room wall. Use the appropriate wall anchors to fasten the mounting blocks to the room wall. For DRYW ALL use #8 x 2 ½” sheet metal screws with Zinc EZ Anchor and for MASONRY use 3/16” x 2 ¾” Tap Con (drill 5/32” pilot hole. Reposition the Textured/Tactile Wall over the mounting blocks. Attach the Textured/Tactile Wall with the screws removed in Step #5.
2.
A
B
3.
½”
C
4.
WALL
C
C
A
A
5.
B
Floor
6.
7.
800-467-6222
TFH USA LTD.
www.specialneedstoys.com
ALL TFH PRODUCTS SHOULD BE USED WITH ADULT SUPERVISION.